Asphalt Milling Ottawa

Cold planers can remove a shallow surface texture, one asphalt lift, or multiple lifts in separate passes. The safe depth depends on pavement thickness, machine size, underlying material, utilities, and the rehabilitation design. Harrowgate verifies cores and depth continuously so the remaining pavement is not unintentionally broken or reduced below the planned section.

Milling cuts a controlled depth and leaves a textured, profile-controlled surface suitable for repair and overlay. Full asphalt removal takes all pavement to granular or another substrate, usually where the structure is being reconstructed. Harrowgate uses milling for retained layers and sawcut excavation where deep failures or thin remaining asphalt make precision planing unsuitable.

Temporary traffic can use an accepted milled surface when transitions, drainage, loose material, structures, and groove texture are safe for the vehicle and speed. It is not the preferred long-term condition. Harrowgate sweeps thoroughly, builds approved ramps, protects exposed structures, and schedules repairs and paving promptly to limit ravelling and water entry.

Structures are located, marked, and exposed with reduced production speed and controlled depth. The large mill leaves a safe offset, then a small mill or hand equipment completes the perimeter. Frame condition and elevation are inspected before resurfacing, and unstable adjustment units are rebuilt rather than subjected to planer impact.

Cores reveal actual lift thickness, interfaces, delamination, underlying concrete or granular, and past overlays. Plans and averages can miss thin areas. Core data lets Harrowgate set safe removal depths, identify full-depth repairs, select equipment, and avoid cutting into waterproofing, concrete, fabrics, or embedded systems below the intended lift.

Milled asphalt is conveyed directly into trucks and kept separate from soil, concrete, garbage, and unsuitable material. Clean reclaimed asphalt pavement can be delivered to an approved facility for processing and reuse in permitted mixtures. Harrowgate controls truck loading, route cleanliness, and final sweeping so valuable material is not contaminated or lost.

Milling can remove high points, wheel-path ruts, and selected profile defects when the civil design establishes a new drainage plane. It cannot raise low areas or correct deep settlement by itself. Harrowgate combines profile milling with base repairs, levelling mix, structure adjustment, and new asphalt lifts to achieve the final crossfall and outlet elevations.

Survey, ski or grade control, machine calibration, operator checks, yield, exposed layer condition, and frequent depth measurements maintain the designed profile.

Only under an approved temporary traffic plan; texture, grooves, drop-offs, drainage, structures, loose debris, motorcycles, and weather affect safe use.